MUTOH Falcon II Outdoor Maintenance Manual page 312

5 Nothing has been printed
6 Only specific colours are not
printed.
Falcon II Outdoor series printers – Maintenance Manual
(8) Check if the • If "Near End" or
remaining amount of "Ink End" is not
ink in the cartridge displayed when the
is sufficient. remaining amount of
ink is insufficient,
the ink sensor
assembly may have
a problem.
(9) The ink pump • Replace the ink
assembly may have pump assembly.
a problem.
(10) The • Replace the
maintenance maintenance
assembly may have assembly.
a problem.
(11) The Mainboard • Replace the
assembly may have Mainboard
a problem. assembly.
(1) Check the head • Redo the
and CR cables for connections of the
skewed insertion. following
connectors.
Connectors for the
print head.
• CR board : J201 –
J232
• Mainboard : J137
– J152
(2) The head and • Replace the CR
CR cables may be tape power cables.
damaged.
(3) Check ink tubes • Replace the
for bends, flaws, air damaged ink tubes.
leaks, etc.
(4) The print head • Replace the print
assembly may be head assembly.
damaged.
(5) The damper may • Replace the
be damaged. damaged cable.
(6) The ink pump • Replace the ink
assembly may have pump assembly.
a problem.
(7) The • Replace the
maintenance maintenance
assembly may have assembly.
a problem.
312
→ Replacing the I/H
(inkholder)
assembly.
→ Replacing the
pump assembly.
→ Replacing the
maintenance
assembly
→ Replacing the
print head assembly
and head tape
power cable.
→ Replacing the
print head assembly
and head tape
power cable.
→ Replacing the CR
board assembly.
→ Replacing the
print head assembly
and head tape
power cable.
→ Replacing the
steel bearer, tube
guide, CR tape
power cable and ink
tube.
→ Replacing the
steel bearer, tube
guide, CR tape
power cable and ink
tube.
→ Replacing the
print head assembly
and head tape
power cable.
→ Replacing the H
ink tube, tube
branch and damper
assembly.
→ Replacing the
pump assembly.
→ Replacing the
maintenance
assembly.
AP-74065, Rev. 1.0, 21/11/03