MUTOH Falcon II Outdoor Maintenance Manual page 119

Step 3 :
Remove the E ring fixing the cursor roller assembly (KY-80040) of downside.
1 = CR cursor assembly (KY-80040)
Step 4 :
Replace the cursor roller assembly (KY-80040).
Step 5 :
Install the spacers and the other parts as shown in the following figure.
1 = E ring fixing the side cursor roller assembly
3 = Brass spacer of the side cursor roller assembly
5 = High-load bearing of the cursor roller assembly of
downside
Step 6 :
Apply the screw lock to the cursor axis, and install the cursor roller assembly with the axis at the lower position.
Notes :
Be sure that the screw lock does not contaminate the cursor roller or the spacer.
Falcon II Outdoor series printers – Maintenance Manual
2 = E ring fixing the cursor roller assembly.
2 = High-load bearing of the side cursor roller
assembly
4 = E ring of the cursor roller assembly
6 = Brass spacer of the cursor roller assembly
119 AP-74065, Rev. 1.0, 21/11/03