MUTOH Falcon II Outdoor Maintenance Manual page 60

4.3.2.2. Replacing the post fixer (Heater C) on a Falcon II Outdoor 4H printer
Before replacing the heater, make sure to have following items:
50" model : Post Fixer C 50 (EY-80343)
64" model : Post Fixer C 64 (EY-80333)
87" model : Post Fixer C 87 (EY-80353)
1 x sensor insul. Patch (ME-80310)
To replace the post fixer on a Falcon II Outdoor 4H printer, please follow the instructions mentioned below.
Step 1 :
Remove side cover L.
Step 2 :
Remove side cover R.
Step 3 :
Remove the front cover.
Step 4 :
Remove the Y rail cover.
Step 5 :
Remove the front paper guide.
Step 6 :
Remove the post fixer strip.
Step 7 :
Degrease the plate.
Step 8 :
Stick the post fixer strip onto the plate.
Notes :
During reinstallation of the plate, make sure there are no cables stuck.
Notes :
Make sure the plate is cleaned properly. Dust, glue and other parts must be
removed.
Notes :
Make sure that the strips connect properly.
Stick it as close as possible to the assembly holes. Make sure it does not touch the
assembly holes.
Notes :
Please make sure that there are no air bubbles under the heater strip. Air bubbles
below the heater strip could cause overheating of the heater strip.
60
Falcon II Outdoor series printers – Maintenance Manual
AP-74065, Rev. 1.0, 21/11/03