MUTOH Falcon II Outdoor Maintenance Manual page 235

Step 2 : Press simultaneously the [CANCEL] and the [ENTER] key while turning the printer ON.
Step 3 : The display will mention the following message.
Step 4 : Press the [F2] key.
Step 5 : The heater system board is now being updated. The display will mention the following messages.
Step 6 : At the end the display will mention the following message.
Step 7 : Press the [CANCEL] key.
Step 8 : Power OFF the unit.
Step 9 : Updating the heater system board is completed.
* User Setting *
Rem Update
F2 →
Ver Update
Erasing sectors
Wait flash programming
Card Update
DO NOT POWER DOWN
Version Installed
Falcon II Outdoor series printers – Maintenance Manual
(1/1)
235 AP-74065, Rev. 1.0, 21/11/03