MUTOH Falcon II Outdoor Maintenance Manual page 57

Step 11 :
Reinstall all parts in the opposite order of the removal procedure.
4.3.1.2. Replacing the rear heater on a Falcon II Outdoor printer
Before replacing the post fixer, make sure to have following items:
50" model : Heater strip assy rear 50 (EY-80238)
64" model : Heater strip assy rear 64 (EY-80218)
87" model : Heater strip assy rear 87 (EY-80228)
2 x press plate (ME-24134)
Silicone glue (AG-91240)
To replace the rear heater on a Falcon II Outdoor printer, please follow the instructions mentioned below.
Step 1 :
Remove side cover L.
Step 2 :
Remove side cover R.
Step 3 :
Remove the front cover.
Step 4 :
Remove the Y rail cover.
Step 5 :
Remove the rear paper guide.
Step 6 :
Remove the rear heater strip.
Step 7 :
Degrease the plate.
Step 8 :
Stick the rear heater strip onto the plate.
Notes :
During reinstallation of the plate, make sure there are no cables stuck.
Notes :
Make sure the plate is cleaned properly. Dust, glue and other parts must be
removed.
57
Falcon II Outdoor series printers – Maintenance Manual
AP-74065, Rev. 1.0, 21/11/03