MUTOH Falcon II Outdoor Maintenance Manual page 283

8 Warning
Waste INK
Tank
9 Warning
Waste INK
Tank
(2) Check the ink
ID sensor
connector for the
contact conditions.
(3) The Mainboard
may be damaged.
The waste tank will (1) Check if the
soon be full. message is still
displayed after
turning the power
off and then back
on again.
(2) The amount of
waste ink inside
the tank reached
the specified level.
(3) If initialization
does take effect
when the waste ink
is disposed of and
waste ink history is
initialized, the
Mainboard may be
damaged.
The service life of (1) Check if the
the ink tube will message is still
soon be reached. displayed after
turning the power
off and then back
on again.
(2) The number of
times the ink tube
was used reached
the maximum
allowable times.
(3) If initialization
does take effect
when the CR
motor history is
initialized after the
ink tube is
replaced, the
Mainboard may be
damaged.
Falcon II Outdoor series printers – Maintenance Manual
• Redo the
connections of the
following
connectors :
• Junction board :
J401 – J418
• Mainboard : J133
– J134
• Replace the
Mainboard
assembly.
• When a message
is displayed : Go to
step (2)
• Dispose of the
waste ink in the
waste bottle.
• Replace the
Mainboard
assembly.
• When a message
is displayed : Go to
step (2)
• Replace the ink
tube.
• Initializing CR
motor history.
• Replace the
Mainboard
assembly.
283
→ Replacing the
JUNCTION board
assembly.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
-
-
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
-
→ Replacing the
steel bearer, tube
guide, CR tape
power cable and
ink tube.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
AP-74065, Rev. 1.0, 21/11/03