MUTOH Falcon II Outdoor Maintenance Manual page 63

Step 8 :
Remove the screws of the plot platform.
Step 9 :
Pull upwards the plot platform calibre and so remove the plot platform with fixer.
Step 10 :
Remove the fixer.
Step 11 :
Degrease the plot platform.
Step 12 :
Stick the two fixer strips onto the plot platform.
Step 13 :
Stick the isolation tape onto the heater strips.
1 = screws plot platform
Notes :
Make sure the plate is cleaned properly. Dust, glue and other parts must be
removed.
Notes :
Please make sure that there are no air bubbles under the heater strip. Air bubbles
below the heater strip could cause overheating of the heater strip.
63
Falcon II Outdoor series printers – Maintenance Manual
AP-74065, Rev. 1.0, 21/11/03