MUTOH Falcon II Outdoor Maintenance Manual page 294

7 E 070 Error
CR Timeout
Err
Time out occurred in (3) Check if "CR
the head travel (Y- Motor Error"
axis) during occurs by setting
operation. the durability
Displayed when he cycles at 50 over
carriage has not larger via "Life: CR
reached the Motor" of the self-
commanded diagnostic
position. function.
(4) Check the T-
fence for
contamination,
flows and bends.
Falcon II Outdoor series printers – Maintenance Manual
• Check he
connections of the
following
connectors.
Mainboard
assembly
• CR motor
assembly
connector : J158
• CR tape power
cable connectors :
J137 – J152
CR Board
assembly
• CR tape power
cable connectors :
J201 – J216
• CR_ENC
assembly
connector : J233
• If contaminated
with grease and
dust, wipe off with
a dry cloth.
• If contaminated
with ink, wipe off
with a lightly damp
cloth and then with
a dry cloth.
• If contamination
is severe, replace
the T fence.
a) If NG :
Check the cable
connections at the
following locations
• CR board
assembly
connector J233
b) Replace the
following parts
• T fence
• CR motor
assembly
• CR BASE board
assembly
• CR tape power
cables
294
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→ Replacing the
T fence
AP-74065, Rev. 1.0, 21/11/03