MUTOH Falcon II Outdoor Maintenance Manual page 318

Falcon II Outdoor series printers – Maintenance Manual
(5) Check the T • Clean the T fence
fence for • If contaminants
contamination. cannot be cleaned
up by cleaning,
replace the T fence.
(6) Make sure that • If they interfere
the CR_ENC with each other,
assembly and the T adjust the
fence are not installation positions
interfering. of the CR_ENC
assembly and the T
fence.
• If the adjustments
do not improve this,
replace the
CR_ENC assembly
and the T fence.
(7) Check if the • Check that
pump is running connections of
during the cleaning Mainboard
operation. connectors J160-
J161 are good.
• Replace the pump
motor assembly.
• Replace the
Mainboard
assembly.
(8) Check if the • Using the wiper,
nozzle face is wiped wipe the nozzle face
correctly. well.
(9) Check the • Using the provided
cleaning wipers for cleaning cloth for
contamination. cleaning the wipers,
slightly dampen it
with cleaning liquid
and wipe the
surfaces of the
cleaning wipers,
then recheck their
conditions by
performing the
cleaning operation.
• If the ink is solid
and does not come
off by wiping,
replace the wiper.
(10) Check if the QR • Input the correct
code is input QR codes.
correctly.
(11) The head • Replace the
assembly may be damaged head
damaged. assembly
318
→ Replacing the T
fence
→ Replacing the T
fence.
→ Replacing the
CR_ENC assembly
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly
→ Replacing the
pump motor
assembly.
→ User's Guide
→ User's Guide.
→ Replacing the
cleaner
→ Head rank input
menu
→ Replacing the
print head assembly
and head tape
power cable.
AP-74065, Rev. 1.0, 21/11/03