MUTOH Falcon II Outdoor Maintenance Manual page 250

Step 8 :
Adjust head U/D eccentric shaft lever so that CR gap adjustment jig can move freely.
Step 9 :
Perform CR cursor right/left adjustment.
1 = Platen
3 = Print head
5 = Height 1.2 mm
7 = CR gap adjustment jig 1.2 mm side
Step 10 :
Fasten the screws (2, one on the right, one on the left) that fasten the head U/D eccentric shaft lever.
Step 11 :
Apply non reflective tape to the head U/D eccentric shaft lever as shown in the following printing:
Notes :
1 = Head U/D eccentric shaft cover
3 = Screw fixing the head U/D eccentric shaft cover
Completely cover the screw heads with non reflective tape. If non reflective tape
cannot be applied to chosen location, the head slide sensor may not detect screw
head properly.
Falcon II Outdoor series printers – Maintenance Manual
2 = CR gap check jig
4 = CR cursor
6 = Height 1.3 mm
2 = Nonreflective tape
250 AP-74065, Rev. 1.0, 21/11/03