MUTOH Falcon II Outdoor Maintenance Manual page 328

3 The cutting operation is in
process, but the paper has not
been cut.
4 The paper has not been cut as
smoothly as expected, resulting
in jamming.
5 The cutting operation is in
process but the paper does not
fall off.
6 Inaccurate paper cutting
Falcon II Outdoor series printers – Maintenance Manual
(3) Check the CR • Check the
cables for skewed connections of the
insertion. following
connectors.
• CR board : J235
• CR board : J201-
J216
• Mainboard : J137
– J152
(4) The CR board • Replace the CR
may have a board.
problem.
(5) The Mainboard • Replace the
may have a Mainboard .
problem.
(1) Check the cutter • Replace the cutter.
blade for shipping
and deterioration.
(2) Check if the • Reset the cutter
cutter cap is cap securely.
securely installed.
(3) Check if the • Reinstall the cutter
cutter moves up and spring.
down smoothly.
(4) Check the cutter • Remove the
grooves for accumulated paper
accumulated paper dust along the
dust and slips. direction of the
grooves.
(5) Check if the • Make adjustments.
cutter blade is
parallel with the
groove.
(1) The sub-platen • Clean the surface
(cutter groove) of the sub-platen
requires daily
maintenance.
(2) The sub-platen, • Provide a proper
paper guide or the ground.
paper may be • Check and adjust
charged with static the ambient
electricity. humidity so that it
meets the normal
operation conditions
of the product and
paper.
(1) Check the cutter • Replace the cutter.
blade for chipping
and deterioration.
328
→ Replacing the CR
board assembly
→ Replacing the CR
board assembly
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly
→ User's Guide
→ User's Guide
-
→ User's Guide
→ Replacing the
cutter holder, cutter
spring, cutter cap,
solenoid assembly
and solenoid spring.
-
→ User's Guide
AP-74065, Rev. 1.0, 21/11/03