MUTOH Falcon II Outdoor Maintenance Manual page 324

4 You hear some noise when the
paper is fed.
Falcon II Outdoor series printers – Maintenance Manual
(3) Check if rattles • Clean the dust
are heard when the from the carriage
carriage is moving bearings and roller
from side to side. guide. When the
roller guide has
been cleaned, apply
a light coat of
grease on the roller
guide using a cloth
soaked in grease
spray.
• Replace the CR
cursor assembly.
(4) Check the CR • Correct the cable's
cables for noise. tendency and fix the
condition.
• If noise is heard
from between the
steel bearing and
tube guide, replace
the tube guide.
(5) Make sure that • If interference is
the CR_ENC observed, adjust the
assembly and the T installation positions
fence are not of the appropriate
interfering. components.
• If the adjustment
does not improve
this, replace the
appropriate
components.
(6) Check the • Replace the CR
bearings of the CR driven pulley
driven pulley for assembly.
noise.
(7) Check if the • Adjust the steel
tension of the steel belt tension.
belt has been
properly adjusted.
(8) Check the CR • Replace the CR
motor assembly for motor assembly.
noise.
(9) Check the cursor • Replace the cursor
roller of the CR roller.
cursor assembly for
noise.
(1) Check the PF • Replace the PF
reduction belt for the reduction belt.
skipping of teeth
between the belt
and PF reduction
pulley.
(2) Check the PF • Replace the PF
motor assembly for motor assembly.
noise
324
→ Replacing the CR
cursor assembly
→ Replacing the
steel bearer, tube
guide, CR tape
power cable and ink
tube.
→ Replacing the T
fence
→ Replacing the
CR_ENC assembly
→ Replacing the CR
slave pulley
assembly.
→ Steel belt tension
adjustment.
→ Replacing the CR
motor assembly.
→ Replacing the
cursor roller
assembly.
→ Replacing the PF
motor assembly
→ Replacing the PF
motor assembly
AP-74065, Rev. 1.0, 21/11/03