MUTOH Falcon II Outdoor Maintenance Manual page 135

(2) Replacing the ink ID board assembly and the holder pressure spring
Step 1 :
Remove the I/H assembly.
Step 2 :
Remove the 2 screws fixing the holder pressure spring.
1 = Holder pressure spring (two-ply use)
3 = Ink ID board assembly
Step 3 :
Replace the holder pressure spring.
Step 4 :
Remove the SC cable assembly connector from the ink ID board assembly.
Step 5 :
Replace the ink ID board assembly.
Step 6 :
Reinstall all parts in the opposite order of the removal procedure.
(3) Replacing the cartridge frame assembly
Step 1 :
Remove the I/H assembly.
Step 2 :
Remove the cables from the I/H assembly clamp.
Step 3 :
Disengage the hook fixing the cartridge frame assembly, and then slide the cartridge frame assembly in the
direction of the arrow to remove it.
1 = Cartridge frame assembly
Falcon II Outdoor series printers – Maintenance Manual
2 = Screws (M3x6) fixing the holder pressure spring
4 = SC cable assembly
2 = Hook
135 AP-74065, Rev. 1.0, 21/11/03