MUTOH Falcon II Outdoor Maintenance Manual page 59

Step 5 :
Remove the front paper guide.
Step 6 :
Remove the dryer strip(s).
Step 7 :
Degrease the plate.
Step 8 :
Stick the dryer strip(s) onto the plate.
Step 9 :
Stick onto the sensors a sensor insul. patch.
1 = sensor insul. patch
Step 10 :
Reinstall all parts in the opposite order of the removal procedure.
Notes :
Make sure the plate is cleaned properly. Dust, glue and other parts must be
removed.
Notes :
Make sure that the strips connect properly.
Please make sure that the sensor (blue blocks) are positioned on the flat surface of
the front paper guide.
Stick it as close as possible to the assembly holes. Make sure it does not touch the
assembly holes.
Notes :
Please make sure that there are no air bubbles under the heater strip. Air bubbles
below the heater strip could cause overheating of the heater strip.
59
Falcon II Outdoor series printers – Maintenance Manual
2 = assembly hole
AP-74065, Rev. 1.0, 21/11/03