MUTOH Falcon II Outdoor Maintenance Manual page 300

18 E 082 Error
Wiper Sensor
(3) Is the sensor
element of the
transmission
photosensor at the
cap contaminated?
(4) Is the
transmission
photosensor cable
at the lever motor
securely installed?
(5) Make sure that
the connections of
the SLIDE motor
assembly for
maintenance U/D
are good.
(6) The Mainboard
assembly may be
damaged.
Trouble occurred in (1) Check the
the wiper sensor. up/down operation
of he cap (wiper)
via "Sensor:Head
Lock" of the self-
diagnistic function.
(2) Is the
transmission
photosensor at the
wiper up/down
area securely
installed?
(3) Is the sensor
element of the
transmission
photosensor
contaminated?
(4) Is the
transmission
photosensor cable
securely
connected?
Falcon II Outdoor series printers – Maintenance Manual
• Clean the sensor
element using
cotton swabs.
• Securely connect
the cable for the
transmission
photosensor cable
to Mainboard
assembly
connectors J123
and J124.
• Replace the
SLIDE motor
assembly for the
maintenance U/D.
• Replace the
Mainboard
assembly.
• Replace the
transmission
photosensor at the
wiper.
• If the
transmission
photosensor is
detached, fix it
securely.
• Clean the sensor
element using
cotton swabs.
• Securely connect
the cable for the
transmission
photosensor cable
to Mainboard
assembly
connector J131.
300
→ Replacing the
transmission
photosensor.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→ Replacing the
SLIDE motor
assembly (wiper
arm).
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→ Replacing the
transmission
photosensor.
→ Replacing the
transmission
photosensor.
→ Replacing the
transmission
photosensor.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
AP-74065, Rev. 1.0, 21/11/03