Mode Page - Bosch MBV-BPRO-45 Configuration Manual

182 en | Encoders / Decoders page
–
Shutter
Adjusts the electronic shutter speed (AES). Controls the time period for which light is
gathered by the collecting device. The default setting is 1x (60 Hz: 1/30, 50 Hz: 1/25)
Auto SensUp Maximum
Sets the Auto SensUp minimum value. The Auto SensUp Min. value is the factor by which the
sensitivity of the camera is increased. The default setting is 15x
Backlight Comp
–
–
Stabilization
–
–
Night Mode
Selects night mode (Black/White) to enhance lighting in low light scenes. Select from the
following options:
–
–
–
Night Mode Threshold
Adjusts the level of light at which the camera automatically switches out of night mode (B/W)
operation. Select a value between 10 and 55 (in increments of 5), where 10 is earlier and 55 is
later.
18.11.1

Mode page

A mode is a set of image parameters that are set in the camera when that mode is selected
(Installer menu settings are excluded). Six pre-defined modes are available for typical
scenarios. After a mode has been selected, additional changes can be made through the user
interface.
Current mode
Select the mode you wish to use from the drop-down menu.
Mode ID
The name of the selected mode is displayed.
Copy mode to
Select the mode from the drop-down menu to which you wish to copy the active user mode.
Restore Mode Defaults
Click Restore Mode Defaults to restore the factory default modes. Confirm you decision.
2013.03 | V1 | Configuration Client
Auto SensUp: Increases camera sensitivity by increasing the integration time on the CCD.
This is accomplished by integrating the signal from a number of consecutive video frames
to reduce signal noise.
If you select this option, for example the AutoDome Junior HD makes the following
change automatically:
– Auto Iris: Switches to value Constant.
On: Optimizes the video level for the selected area of the image. Parts outside this area
may be underexposed or overexposed.
Off: default setting
On: Turns on video stabilization.
Off: Turns off video stabilization.
Monochrome: Forces the camera to stay in Night Mode and transmit monochrome
images.
Color: The camera does not switch to Night Mode regardless of ambient light conditions.
Auto: The camera switches out of Night Mode after the ambient light level reaches a pre-
defined threshold.
Configuration Manual
Bosch Video Management System
Bosch Sicherheitssysteme GmbH