Programming Overview; Entering Programming Mode; Exiting Programming Mode; Command Menus - Bosch Solution 16plus Installation Manual


T
he Solution 16 Control System incorporates a menu text
plus
driven interface. This interface is very similar to that found
on many mobile phones. Once programming mode is entered
you will see a number of menu options in the display and these
may vary depending in the user authority level.
E N T E R ING PRO GR AM M I N G M OD E
To enter installer program mode enter, PIN + [MENU].
The default Installer PIN is 1234.
The Red and Green LED indicators on the keypad will flash to
confirm Installer programming mode is active.
i
All areas must be disarmed with no active alarms. To disarm all
areas enter the Installer PIN and hold the [OFF] Key for 2 seconds.
Note
E X IT I NG P RO G RA M MI NG M OD E
Press and hold down [MENU] key for 2 seconds.
The system will scan all schedules and peform the functions
relative to the current system. For example if a timed output
should be operated then it will operate and if the system should
be armed it will arm.
i You can also select Exit and press [OK] from each menu level.
Note
COMMAN D M EN US
When you first enter programming mode a special menu called
the Command Menu will appear at the top of the menu tree.
The Command Menu provides a list of the most common
system funtions like "Turn Chime Mode On", "Move To An Area"
or "Turn An Area On".
Use the up and down arrow keys to navigate and press [OK] to
select the command.
PRO G R A MM IN G OP TI O N B I T ME NU S
Use the up and down arrow keys to scroll through the 8 different
options. To enable an option, press the [ON] key – a tick will be
displayed. To disable an option, press the [OFF] key.
Off On Low Battery
Show Overload
 Report Overload
Press 
Bosch Security Systems 05/10 BLCC100I

Programming Overview

OK ON OFF MENU
To save programming changes, press [OK] or press [MENU] to
exit without saving.
NAVIGATIN G THE ME NU S
Using the up and down arrow keys to navigate, locate the
desired menu item using the highlight bar and then press the
[OK] key to select.
A new list of menu items will appear. Repeat the above until the
desired menu item is located.
To navigate backwards through the menu items press the
[MENU] key at any time. Alternatively if you know the direct
menu item number press [MENU] + Item Number.
Key
 Scrolls Cursor Left
 Scrolls Cursor Right

Scrolls Cursor Up

Scrolls Cursor Down
OK Enter Menu Options or Saves Changes
Go Back One Level, Abort Current Change or
MENU
Hold Down to Exit Programming Mode
0 to 9 Enter Data Value
ON
Turn On Bit Option
OFF
Turn Off Bit Option, Clear to End of Line
Table 12: Keys Used During Programming

LIST OPTIONS

Use the up and down arrow keys to step through the available
options. Press [OK] to save or [MENU] to exit without saving.
ZONE TYPE ZN001
01 - Burglary Delay 1

PRESS
i
You can also enter the option number directly followed by [OK].
You must press the [OK] a second time to confirm the current
Note setting.
SECT ION 4
Description
0-9, OK or MENU
4-1