Table of Contents
Advertisement
194
en | Encoders / Decoders page
4
If either of these ranges are set, no IP V6 addresses are allowed to actively connect to the
device.
The device itself may initiate a connection (for example, to send an alarm) outside the defined
ranges if it is configured to do so.
18.26
Licenses page
This page allows you to enable additional functions or software modules.
Installation code
Displays the installation code.
Activation key
Type the activation key. The activation key cannot be deactivated and is not transferable to
other units.
Installed licenses
Displays the installed licenses after their activation.
18.27
Decoder page
18.27.1
Decoder profile
Allows you to set the various options for the display of video images on an analog monitor or
VGA monitor.
Monitor name
Type the name of the monitor. The monitor name facilitates the identification of the remote
monitor location. Use a name that makes it as easy as possible to identify the location.
Click
Standard
Select the video output signal of the monitor you are using. Eight pre-configured settings for
the VGA monitors are available in addition to the PAL and NTSC options for analog video
monitors.
Caution!
Selecting a VGA setting with values outside the technical specification of the monitor can re-
sult in severe damage to the monitor. Refer to the technical documentation of the monitor
you are using.
Window layout
Select the default image layout for the monitor.
VGA screen size
Type the aspect ratio of the screen (for example 4 x 3) or the physical size of the screen in
millimeters. The device uses this information to accurately scale the video image for
distortion-free display.
18.27.2
Monitor display
The device recognizes transmission interruptions and displays a warning on the monitor.
2013.03 | V1 | Configuration Client
Click Set and confirm to restrict access.
to update the name in the Device Tree.
Configuration Manual
Bosch Video Management System
Bosch Sicherheitssysteme GmbH
Advertisement
Table of Contents
