Table of Contents
Advertisement
174
en | Encoders / Decoders page
Title OSD
OSD titles can be displayed at a position of your choice.
–
–
–
Camera OSD
Displays camera information, such as Digital Zoom, Iris open/close, and Focus near/far
overlays in the image.
–
–
18.3.1
Picture settings
Allows you to adjust each video image to your requirements. All changes are displayed
immediately. Be aware that changes in the image quality affects processor performance.
Video
Enter the number of the camera you want to adjust. If you want to do this for each camera,
enter the number of the camera, adjust the settings (brightness, contrast, etc.), and then
enter the next camera number, and adjust their settings.
Brightness
Enter the value to adjust the brightness of the video image to your working environment.
Contrast
Enter the value to adjust the contrast of the video image to your working environment.
Saturation
Enter the value to adjust the color saturation of the video image on your monitor as realistic as
possible.
Low-pass filter
Enter the value to remove very fine noise from the image. This reduces and optimizes the
bandwidth necessary for the image transmission over the network. The image resolution may
be impaired. The higher the value, the flatter the image signal.
Default
Click to change the current settings to the factory settings.
Show Image
Click to display the image window of the encoder. In the menu bar of the video image you can
select the video input that you want to display.
18.3.2
Input termination
Allows you to activate or deactivate the 75 Ohm terminating resistor for each video input.
The numbering follows the labeling of the video inputs on the device. Every video input is
closed at the time of delivery.
75 Ohm termination
Select one of the following:
–
2013.03 | V1 | Configuration Client
On
Continuously displays sector or shot title overlays in the image. Enter the position.
Off
Does not displays sector or shot title overlays in the image.
Momentary
Continuously displays sector or shot title overlays in the image for a few seconds. Enter
the position.
On
Displays camera information in the window. Enter the position.
Off
Does not display camera information in the window.
Off: Deactivates the 75 Ohm terminating resistor and loops through the video signal.
Configuration Manual
Bosch Video Management System
Bosch Sicherheitssysteme GmbH
Advertisement
Table of Contents
