Table of Contents
Advertisement
Bosch Video Management System
Allegiant CCL commands supported in Bosch VMS lists the CCL commands supported in
Bosch Video Management System.
Note:
Do not configure the Allegiant CCL emulation and an Allegiant device to the same COM port. If
for both devices the same COM port is configured, the Allegiant device wins. The access of the
Allegiant CCL emulation device fails with an appropriate message.
To solve this, the Management Server must have two different COM ports or connect the
Allegiant device to another computer.
Enable Allegiant CCL Emulation
Select the check box to enable the emulation.
Baud rate
Select the value for the transmission rate in bit/s.
Stop bits
Select the number of stop bits per character.
Parity check
Select the type of parity check.
Interface mode
Select the desired protocol for the serial interface.
Half-duplex mode
Select the setting appropriate for your application.
17.25
Mobile Video Service page
Main window >
Allows you to add one or more transcoding service entries to your Bosch VMS. This
transcoding service adapts the video stream from a camera configured in Bosch VMS to the
available network bandwidth. This enables mobile video clients like an iPhone, iPad or Web
Client to receive live or playback video data via unreliable network connections with limited
bandwidth.
See also
–
17.25.1
Add Mobile Video Service dialog box
Main window >
URI
Type in the URI of your Mobile Video Service. Follow the syntax rules of the example:
https://www.MyDomain.org/mvs
You must start the entry always with https://, even when you did not configure an encrypted
access to your Web server.
See also
–
Bosch Sicherheitssysteme GmbH
Devices >
Adding a Mobile Video Service, page 75
Devices > Right-click
Adding a Mobile Video Service, page 75
Configuration Manual
Devices page | en
> Click Add Mobile Video Service
2013.03 | V1 | Configuration Client
159
Advertisement
Table of Contents
