Table of Contents
Advertisement
Bosch Video Management System
Notice!
i
IP devices can be connected that do not have all configuration pages that are described here.
7.8
Configuring a decoder for use with a Bosch IntuiKey keyboard
Main window >
Perform the following steps to configure a VIP XD decoder that is connected to a Bosch
IntuiKey keyboard.
To configure a decoder:
1.
2.
3.
7.9
Configuring multiple encoders / decoders
Main window
You can modify the following properties of multiple encoders and decoders at once:
–
–
–
Notice!
i
Changing the IP address of an IP device can make it unreachable.
To configure multiple IP addresses:
1.
2.
3.
4.
5.
6.
7.
To configure multiple display names:
1.
2.
Bosch Sicherheitssysteme GmbH
Devices > Expand
Click the appropriate decoder which is used for connecting a Bosch IntuiKey keyboard.
Click the Periphery tab.
Ensure that the following settings are applied:
–
Serial port function: Transparent
–
Baud rate: 19200
–
Stop bits: 1
–
Parity check: None
–
Interface mode: RS232
–
Half-duplex mode: Off
Display names
IP addresses
Firmware versions
On the Hardware menu, click IP Device Configuration.... The IP Device Configuration
dialog box is displayed.
Select the required devices. You can select multiple devices by pressing the CTRL- or the
SHIFT-key.
Right-click the selected devices and click Set IP Addresses.... The Set IP Addresses
dialog box is displayed.
In the Start with: field, type the first IP address.
Click Calculate. In the End with: field, the last IP address of the range for the selected
devices is displayed.
Click OK.
In the IP Device Configuration... dialog box, click Apply.
The new IP addresses are updated in the selected devices.
On the Hardware menu, click IP Device Configuration.... The IP Device Configuration
dialog box is displayed.
Select the required devices. Multiple selection is possible by pressing the SHIFT key.
> Expand
Configuration Manual
Configuring devices | en
2013.03 | V1 | Configuration Client
69
Advertisement
Table of Contents
