Table of Contents
Advertisement
Bosch Video Management System
URL
In the list, select the IP address or the URL of the desired VSG device.
Bosch device: IP address or DNS name
ONVIF: URL (starts with http)
User name
Type in the user name for logon to the device, usually service.
Password
Type in the password for logon to the device.
Connect
Click to connect to the device and to assign it to VSG.
When logon is successful, configure the protocol settings if required.
Skip
Click to activate the configuration settings in the Protocol settings group.
This button does not appear, if you configure a camera that was detected by network scan and
added by clicking
click the Add... or the Edit... button.
Protocol settings
Make the desired protocol settings. Note that the available configuration settings change with
the selected entry in the Type list.
Type
Note: The available configuration settings change with the selected entry.
Entry in the Type list
Bosch RCP+
Bosch Sicherheitssysteme GmbH
. The button appears, if you select a line in the VSG cameras list and
Available configuration settings
Video input
Select the number of the desired camera if you configure
a multichannel device.
Stream
Select the number of the stream of the selected camera.
Protocol
TCP
Used for transmission in the Internet and / or for lossless
data transmission. Ensures that no data packet gets lost.
Bandwidth requirement can be high.
Use if the device is located behind a Firewall. Does not
support multicast.
UDP
Used for connectionless and lightweight data
transmission in private networks. Data packets can get
lost. Bandwidth requirement can be low.
Supports multicast.
Configuration Manual
Devices page | en
167
2013.03 | V1 | Configuration Client
Advertisement
Table of Contents
