Table of Contents
Advertisement
Bosch Video Management System
Streaming
Select the check box to activate multicast streaming mode for the relevant stream. The device
even streams multicast data if no connection is active.
For normal multicast operation, streaming is typically not required.
Packet TTL (only for Dinion IP, Gen4 and FlexiDome)
Enter a value to specify how long the multicast data packets are active on the network. If
multicast is to be run via a router, the value must be greater than 1.
18.24
FTP Posting page
18.24.1
JPEG posting
This function allows you to save individual JPEG images on an FTP server at specific intervals.
Then, retrieve these images at a later date to reconstruct alarm events, if required.
Image size
Select the resolution for the JPEG images.
File name
Select how file names are created for the individual images that are transmitted.
–
–
–
Posting interval (s; 0 = Off)
Enter the interval in seconds at which the images is sent to an FTP server. Enter zero for no
images to be sent.
18.24.2
FTP server
FTP server IP address
Type the IP address of the FTP server on which to save the JPEG images.
FTP server login
Type your login name for the FTP server.
FTP server password
Type the password for the FTP server.
Path on FTP server
Type the exact path where to save the images on the FTP server.
Post JPEG from camera
Select the check box to activate the camera input for the JPEG image. The numbering follows
the labeling of the video inputs on the device.
Max. bit rate
You can limit the bit rate for FTP posting.
18.25
IP v4 Filter
To restrict the range of IP addresses within which you can actively connect to the device, fill-in
an IP address and mask. Two ranges can be defined.
Bosch Sicherheitssysteme GmbH
Overwrite
The same file name is always used. An existing file is overwritten by the current file.
Increment
A number from 000 to 255 is added to the file name and automatically incremented by 1.
When the number reaches 255, the number starts again from 000.
Date/time suffix
The date and time are automatically added to the file name. Ensure that the date and
time of the device are always set correctly. For example, the file snap011008_114530.jpg
was stored on October 1, 2008 at 11.45 and 30 seconds.
Configuration Manual
Encoders / Decoders page | en
2013.03 | V1 | Configuration Client
193
Advertisement
Table of Contents
