Adding A Bosch Atm/Pos Bridge - Bosch MBV-BPRO-45 Configuration Manual

122 en | Configuration examples
5.
The following screenshot shows an example:
15.2

Adding a Bosch ATM/POS bridge

This example describes how to set up a Bosch ATM/POS bridge.
Configuring the ATM/POS bridge
1.
2.
3.
4.
5.
6.
7.
8.
2013.03 | V1 | Configuration Client
Configure the credentials and the device permissions as required.
Ensure that the device is powered.
To configure the IP address and subnet mask of the device connect it to a COM port of
your computer with a RS232 cable (use the specified Bosch cable for connection). See
the Installation Manual of the Bosch ATM/POS bridge for details.
On this computer, start a Hyper terminal session (usually: Start > Programs >
Accessories > Communications > Hyper Terminal).
Type a name for the session and click OK.
Select the COM port number and click OK.
Enter the following COM port settings:
– 9600 bits/s
– 8 data bits
– no parity
– 1 stop bit
– hardware flow control
Click OK.
Press F1 for displaying the system options menu of the device.
Enter 1 to set the IP address and the subnet mask as required.
Configuration Manual
Bosch Video Management System
Bosch Sicherheitssysteme GmbH