A
CM35
Assign the call direction to the trunk route.
Specify the answer signal from the distant of-
fice for outgoing connection to the trunk route.
Specify the release signal from the distant of-
fice for an outgoing connection of an incoming
connection to the trunk route.
NOTE:
In case of Adjunct Type (Analog In-
terface), using a line card over the
Main PBX is recommended to pro-
vide the release signal (i.e., momen-
tarily, an open circuit).
Assign the sending of the dial pulse on an out-
going call to the trunk route.
Assign the incoming connection signaling to
the trunk route.
Assign the sending Switch Hook Flash for Ad-
junct Analog System.
Assign the Sender start condition to the trunk
route.
B
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
TRUNK DATA PROGRAMMING (For Adjunct Analog)
•
Y=02
(1)
00-63: Trunk Route No.
(2)
3 : Bothway Trunk
•
Y=04
(1)
00-63: Trunk Route No.
(2)
1: Battery Reversal
•
Y=05
(1)
00-63: Trunk Route No.
(2)
1 : Release signal arrives
•
Y=08
(1)
00-63: Trunk Route No.
(2)
3 : Dial pulses are sent out
•
Y=09
(1)
00-63: Trunk Route No.
(2)
15 : Ring Down (Loop Start C.O.)
•
Y=169
(1)
00-63: Trunk Route No.
(2)
0: To send
•
Y=20
(1)
00-63: Trunk Route No.
(2)
15 : Timing Start
– 124 –
DATA
NWA-008855-001 Rev.1.0
avch3001.fm