NEC NEAX 2000 IPS Manual page 125

L
CMAD Assign a PAD data to each IP-CS, if required.
NOTE:
For changing these PAD data by
CMAD Y=01/08/09/10, Make Busy/
Make Idle of IP-CS (CME5 Y=3) is
not required.
2ND DATA
00
09
15
T: Transmitter (PS to IP-CS) PAD (dB)/R: Receiver (IP-CS to PS) PAD (dB)
+: Gain
CMAE Assign the CS number of the Control CS
which has a SYS-ID.
Set the Control Signal Mode of the Calling Ar-
ea.
NOTE: The Mode is assigned according to the traffic. When the accommodated IP-CS encounters
high traffic in its radio zone, select the mode to 02 Crowded Mode, so that the IP-CS man-
ages to process the calls, but the PS uses much more battery than Normal Mode.
Specify the width of the Calling Area.
When there are many IP-CSs in the Calling
Area and each IP-CS covers a narrow area, fol-
low the initial data setting 3.
When a IP-CS covers a wide area, set the data
to 1.
M
DESCRIPTION
Y=01
(IP-CS and COT/
ODT/DID/IPT)
0/0
+6/0
0/0
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=01/08/09/10 Connecting Patterns
(1) 000-255: CS No.
(2) See the following table:
PAD DATA (T/R)
Y=08
(IP-CS and DTI/
(IP-CS and LC/
BRT/PRT/CCT/
Virtual IPT)
0/0
+6/0
0/0
• Y=00
(1) 09: CS No. of CS with SYS-ID
(2) 000-255: LEN
• Y=10
(1) 00-31: Calling Area No.
(2) 02 : Crowded Mode
15 : Normal Mode
• Y=11
(1) 00-31: Calling Area No.
(2) 1 : Wide
3 : Narrow
– 115 –
CS DATA PROGRAMMING
DATA
Y=09
Y=10
(IP-CS and CSI)
DLC/ILC)
0/0
+6/0 +6/0
0/+6 0/+6
NWA-008855-001 Rev.1.0
0/0
avch3001.fm