NEC NEAX 2000 IPS Manual page 112

E
CMAE Assign the LEN of the Control CS which has a
SYS-ID.
Set the Control Signal Mode of the Calling Ar-
ea.
NOTE:
The Mode is assigned according to the traffic. When the accommodated CS encounters
high traffic in its radio zone, select the mode to 02 Crowded Mode, so that the CS manages
to process the calls, but the PS uses much more battery than Normal Mode.
Specify the width of the Calling Area.
When there are many CSs in the Calling Area
and each CS covers a narrow area, follow the
initial data setting 3.
When a CS covers a wide area, set the data to
1.
Specify the Control Channel Slot used for
Handover as 00.
NOTE: This assignment is required only
when BS31 is accommodated.
Assign the delay correction data for Handover
when the BS31 is used together with the BS21/
BS21A.
NOTE: This assignment is required only
when BS31 is accommodated.
CME5 After assigning the CS data, Make Idle the CS
by this command.
When the CS data has been assigned by CM14,
the CS automatically becomes Make Busy
state.
END
DESCRIPTION
CSH INITIAL
CSH INITIAL
CSH INITIAL
CSH INITIAL
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=00
(1) 02: Assignment of CS with SYS-ID
(2) 000-758: LEN
• Y=10
(1) 00-31: Calling Area No.
(2) 02 : Crowded Mode
15 : Normal Mode
• Y=11
(1) 00-31: Calling Area No.
(2) 1 : Wide
3 : Narrow
• Y=19
(1) 00: Assignment of Control Channel Slot
(2) 00: Control Channel Slot No. 00
• Y=19
(1) 01: Delay Correction
(2) 03
NONE : Only BS31 is used
• Y=3
(1) 000-255: CS No.
(2) 0 : Make Busy (Forced)
1 : Make Idle
2 : Make Busy after calls finished
– 102 –
CS DATA PROGRAMMING
DATA
: BS31 and BS21/BS21A are used
NWA-008855-001 Rev.1.0
avch3001.fm