NEC NEAX 2000 IPS Manual page 80
Internet protocol server wcs system manual (phs) (for series 3300 or later)
Hide thumbs
Also See for NEAX 2000 IPS:
- Command manual (1038 pages) ,
- Installation manual (619 pages) ,
- System manual (448 pages)
Table of Contents
Advertisement
STEP3: Register the data.
By the command registration, the data is assigned and read. Finally, reboot the IP-CS and load
the assigned data.
(a) Set the use of DHCP server to off.
NOTE:
Default data is set as the use of DHCP server is "on" so invalidate the use of DHCP server.
Command: set dhcp off
IPCS-Connect OK!!
>set dhcp off
set done
The "set done" message is indicated when the IP-CS has received the assigned data normally.
Assigned data can be read by entering "show dhcp" command. Default data is "on" (DHCP sever
is available to use).
(b) Set IP Address and Subnet Mask of IP-CS
Command: set ipadr
Example:
IP Address: 10.41.207.20
Subnet Mask: 255.255.255.0
>set ipadr 10.41.207.20 : 255.255.255.0
The "set done" message is indicated when the IP-CS has received the assigned data normally.
When the data can be read by entering "show ipadr" command.
– 70 –
CHAPTER 2 INSTALLATION
SETUP OF IP-CS
NWA-008855-001 Rev.1.0
avch2001.fm
Advertisement
Table of Contents
