NEC NEAX 2000 IPS Manual page 148

To display the calling information on PS when a call is terminated from a Trunk:
• When a Caller ID signal is sent from a network, do the programming only START to A on
• When a Caller ID signal is not sent from a network, and to display the Trunk name on PS when a call
is terminated from a Trunk (individual signal line), do the following programming in addition to the
programming on
[Series 3500 software required]
A
CM08 Specify the calling information displayed on
PS when a call is terminated from a individual
signal line trunk.
CM35 Assign a trunk name number to each trunk
route.
CM77 Enter the desired trunk name to each trunk
route by CM77 Y=2 or CM77 Y=3.
NOTE 1:
NOTE 2:
END
Page 136.
DESCRIPTION
The trunk name display is provided on a trunk-route basis. The maximum amount of char-
acters in the trunk name is four. The maximum number of trunk routes assignable is 16.
The MAT or CAT can be used to register or change a trunk name display.
There are two ways to change a name that is currently programmed. (1) Overwriting with
a new name, or (2) inserting a blank space as the first character will cancel the existing
name.
CHAPTER 3 SYSTEM DATA PROGRAMMING
(1) 556
(2) 0 : Trunk name assigned by CM77 Y=2/
CM77 Y=3
1 : Not displayed
• Y=03
(1) 00-63: Trunk Route No.
(2) 00-14: Trunk Name No. 00-14
15 : Kind of trunk route assigned by
16-63: Trunk Name No. 16-63
• Y=2 By Character Code
(1) 00-14, 16-63: Trunk route name No.
(2) Character Code 20-7F: Maximum 8 digits
See Character Code Table.
Page 141
• Y=3 By Character
(1) 00-14, 16-63: Trunk route name No.
(2) A-Z, 0-9: Character
Maximum 4 Characters
– 138 –
WCS FEATURE PROGRAMMING
DATA
CM35 Y=00 is displayed
assigned by CM35 Y=03
assigned by CM35 Y=03
NWA-008855-001 Rev.1.0
Page 136.
avch3001.fm