Ccis Interface - NEC NEAX 2000 IPS Manual

CCIS Interface

General Description
This feature allows the WCS to be integrated with NEC PBXs with CCIS interface.
Configuration Application
Adjunct Type with CCIS interface
Operating Procedure
To place a call using Quick Dialing:
1. Press the L1 key and receive extension dial tone.
2. Dial the desired number and receive ringback tone.
To place a call using Preset Dialing:
1. Dial the desired number, press the L1 key, and receive ringback tone.
To place an outside call using Quick Dialing:
1. Press the L1 key and receive extension dial tone.
2. Dial the trunk access code.
3. Receive outside dial tone.
4. Dial the desired outside number and receive ringback tone.
To place an outside call using Preset Dialing:
1. Dial the trunk access code and the desired outside number, press the L1 key, and receive ringback tone.
To send the DTMF signal:
1. While engaged in a call, press any dial key. DTMF signal is automatically sent from the WCS to the other
party.
* Refer to the description of the feature, DTMF Signal Sender.
To place a call on Consultation Hold:
1. While engaged in a call, press the TRF key, and receive Feature Dial Tone. The called party hears Music on
Hold, if the PBX provides the service.
Page 10
Issue 6
CCIS Interface
ND-91638-007(E)