NEC NEAX 2000 IPS Manual page 149

To display the calling information on PS when a call is terminated from an Attendant Console:
[Series 3500 software required]
• To display an attendant console name, do the following programming in addition to the programming
on Page 136.
A
CM77 Enter the desired ATTCON user's name to
each ATTCON number by CM77 Y=A or
CM77 Y=B.
NOTE:
CM08 Specify the calling information displayed on
PS when an Attendant Console calls a PS with
consultation holding the other station/trunk.
END
DESCRIPTION
There are two ways to change a name that is currently programmed. (1) Overwriting with
a new name, or (2) inserting a blank space as the first character will cancel the existing
name.
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=A By Character Code
(1) 0-7: ATTCON No. assigned by CM14/
CM10
(2) Character Code 20-7F: Maximum 32 digits
See Character Code Table.
Page 141
• Y=B By Character
(1) 0-7: ATTCON No. assigned by CM14/
CM10
(2) A-Z, 0-9: Character
Maximum 16 Characters
(1) 554
(2) 0 : Information of holding call
(Station/Trunk information)
1 : Information of Attendant Console
– 139 –
WCS FEATURE PROGRAMMING
DATA
NWA-008855-001 Rev.1.0
avch3001.fm