Hard Disk Drives
The Intel® Server System SR1530CL and Intel® Server System SR1530HCL provide six
SATA ports and one IDE connection. The six SATA ports are located near the front left
side of the server board. An IDE device can be connected to the standard IDE connector
located near the SATA ports.
The Intel® Server System SR1530HCLS provides two SATA and four SAS ports as well
as one IDE connection. The two SATA and four SAS ports are located near the front left
side of the server board. An IDE device can be connected to the standard IDE connector
located near the SATA ports.
Note: Drives can consume up to 17 watts of power each. Drives must be specified to run at a
maximum ambient temperature of 45
Note: The Intel
SAS/SATA hard drives. See
a list of supported hardware.
Slimline Optical Drive
One slimline drive carrier is included with your server system; the optical drive must be
purchased separately.
Note: The Intel
slimline optical drives. See
a list of supported hardware. Intel provides accessory kits for these drives.
For installation instructions for an optical drive, see
Optical Drive" on page
®
Intel
Server System SR1530CL / SR1530HCL / SR1530HCLS
®
Server System SR1530CL / SR1530HCL / SR1530HCLS does not support all
"Server System References" on page ix
®
Server System SR1530CL / SR1530HCL / SR1530HCLS does not support all
"Server System References" on page ix
49.
o
C.
"Installing or Removing a Slimline
for an Internet link to
for an Internet link to
9