Removing A Hard Disk Drive (Sr1530Cl); Figure 40. Removing Drive Carrier From The Server System (Sr1530Cl) - Intel SR1530CL User Manual

13. Install the server system cover. For instructions, see
Cover" on page

Removing a Hard Disk Drive (SR1530CL)

1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
4. Disconnect the power and data cables from the drive.
5. HDD1 location only: Slide the power cable from the cable clip that is located on the
top of the hard drive carrier.
6. Remove the screw that holds the hard drive bracket to the chassis (see letter "A" in
the following figure). Save this screw. You will use it later to reinstall the drive
assembly. Lift the drive carrier from the chassis (see letter "B").

Figure 40. Removing Drive Carrier from the Server System (SR1530CL)

7. Remove the four screws that attach the hard drive to the drive carrier. Lift the drive
from the carrier. Store the drive in an anti-static bag.
8. If you are installing a new drive, skip the rest of these steps and instead see
"Installing a Hard Disk Drive (SR1530CL)" on page
9. Insert the screws that held the drive in the carrier into the screw locations on the
carrier for future use.
44
29.
iii.
28.
A
®
Intel Server System SR1530CL / SR1530HCL / SR1530HCLS
"Installing the Server System
"Removing the Server
B
AF001050
41, beginning with step 7.
"Safety