Removing A Hot-Swap Sas/Sata Drive (Sr1530Hcl/Sr1530Hcls); Figure 45. Installing Drive Assembly Into Server System (Sr1530Hcl/Sr1530Hcls) - Intel SR1530CL User Manual

6. With the black lever in the fully open position, slide the drive assembly into the
server system (see letter "A" in the following figure). The green latch at the front of
the drive carrier must be to the right. Do not push on the black drive carrier lever
until the lever begins to close by itself.
When the black drive carrier lever begins to close by itself, push on it to lock the
drive assembly into place (see letter "B").
Figure 45. Installing Drive Assembly into Server System (SR1530HCL/
7. Install the server system cover. For instructions, see
Cover" on page
8. (Optional) Install the front bezel. For instructions, see
on page
9. Plug all peripheral devices and the AC power cable(s) into the server.
Removing a Hot-Swap SAS/SATA Drive (SR1530HCL/
SR1530HCLS)
1. Remove the front bezel if it is installed. For instructions, see
Bezel" on page
2. Press in on the green latch at the front of the hard drive carrier.
3. Pull out on the black lever to slide the carrier from the server system.
4. Remove the four screws that attach the hard drive to the drive carrier. Lift the drive
from the carrier. Store the drive in an anti-static bag.
5. If you are not installing a new drive, place the plastic retention device into the drive
carrier using the four screws you removed from the hard drive.
6. Insert the screws that held the drive in the carrier into the screw locations on the
carrier for future use.
48
A
B
SR1530HCLS)
29.
27.
26.
®
Intel
"Installing the Server System
Server System SR1530CL / SR1530HCL / SR1530HCLS
AF001622
"Installing the Front Bezel"
"Removing the Front