Removing And Installing The Server Cover; Removing The Server System Cover; Figure 20. Removing The Server System Cover (Sr1530Cl) - Intel SR1530CL User Manual

Removing and Installing the Server Cover

Removing the Server System Cover

The server system must be operated with the server system cover in place to ensure proper
cooling. You will need to remove the cover to add or replace components inside of the
server.
None of the internal components are hot-swappable. Before removing the server system
cover, power down the server and unplug all peripheral devices and the AC power cable.
Note: A nonskid surface or a stop behind the server system may be needed to prevent the server
system from sliding on your work surface.
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord.
4. (SR1530CL) Remove the two screws at the front of the chassis (see letter "A" in
the following figure). Loosen the screw at the rear of the chassis (see letter "B").
Push rearward on the blue grip point at the front of the server. Slide the cover back
until it stops and then lift the cover upward to remove it.. See letter "C".
28
iii.
A

Figure 20. Removing the Server System Cover (SR1530CL)

Intel
C
®
Server System SR1530CL / SR1530HCL / SR1530HCLS
"Safety
B
AF000971