Removing The Heat Sink And Processor; Installing And Removing A Hard Drive (Sr1530Cl) - Intel SR1530CL User Manual

Removing the Heat Sink and Processor

1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
4. Loosen the four captive screws on the corners of the heat sink.
5. Twist the heat sink slightly to break the seal between the heat sink and the
processor.
6. Lift the heat sink from the processor. If it does not pull up easily, twist the heat sink
again. Do not force the heat sink from the processor. Doing so could damage the
processor.
7. Lift the processor lever.
8. Raise the CPU load plate.
9. Remove the processor.
10. If installing a replacement processor, see
Otherwise, install the protective socket cover over the empty processor socket and
then reinstall the chassis cover.
Installing and Removing a Hard Drive
(SR1530CL)
Caution: The hard drives are NOT hot swappable. Before removing or replacing a hard drive, you
must first take the server out of service, turn off all peripheral devices connected to the
system, turn off the system by pressing the power button, and unplug the AC power cord
from the system or wall outlet.
Up to two SATA drives can be installed. The HDD0 drive bay is at the left side of the
chassis, underneath the optional CD-ROM drive. The HDD1 drive bay is at the right side
of the chassis. The drives do not need to be installed in order; HDD1 can be installed
before HDD0.
Note: The server system does not support all hard drives. See
page ix"
40
iii.
28.
for an Internet link to a list of supported hardware.
"Installing the Processor" on page
®
Intel Server System SR1530CL / SR1530HCL / SR1530HCLS
"Removing the Server
"Server System References" on
"Safety
36.