Figure 44. Installing Drive Into Drive Carrier (Sr1530Hcl/Sr1530Hcls) - Intel SR1530CL User Manual

4. Pull out on the black lever and slide the carrier from the server system.
5. Remove the four screws that attach the plastic retention device or the previously
installed hard drive to the drive carrier. Two screws are at each side of the retention
device of the hard drive. Store the plastic retention device for future use. See letter
"A" in the following figure.
Remove the hard drive from its wrapper and place it on an anti-static surface. Set
any jumpers and/or switches on the drive according to the drive manufacturer's
instructions.
With the drive circuit-side down, position the connector end of the drive so that it is
facing the rear of the drive carrier.
Align the holes in the drive to the holes in the drive carrier and attach the drive to
the carrier with the screws that were formerly attached to the plastic retention
device (see letter "B").

Figure 44. Installing Drive into Drive Carrier (SR1530HCL/SR1530HCLS)

®
Intel Server System SR1530CL / SR1530HCL / SR1530HCLS
A
B
AF001621
47