Table of Contents
Advertisement
2 Getting Started
Turning on the
scanner/microimager
A-61096 June 1999
The following steps are necessary to prepare the scanner/microimager
for operation. Procedures on how to perform these steps are described
in this chapter.
1. Turn on the main power switch.
2. Turn on the side panel switch.
3. Select the language display.
4. Load the film into the cassette(s).
5. Load the cassette(s) into the scanner/microimager.
6. Change the lens holder position.
7. Select the mask.
8. Calibrate the scanner/microimager (if applicable).
9. Adjust the feed and separator roller gap.
10. Adjust the feed shelf position.
11. Adjust the feed shelf side guides.
12. Adjust the feed shelf side extension (if applicable).
13. Adjust the exit hopper side guides and end stop.
14. Change the deflector (if required).
15. Run an Exposure Step Test (if required).
16. Prepare the documents for filming/scanning.
Follow the steps below to turn the power on to the scanner/
microimager.
1. Turn on the main power switch (located at the rear of the machine).
NOTE: It is not necessary to turn off the main power switch during
normal daily operations.
2. Turn on the side panel switch.
Wait until the status display indicators are lit and an operating display
appears before continuing.
40X
2-1
Advertisement
Table of Contents
