Table of Contents
Advertisement
Feeding thick
documents
3-6
The gap release lever is used to feed thick documents such as card
stock or cover stock. The lever is located on the front panel of the
scanner/microimager, next to the gap adjustment knob.
Gap adjustment knob
1. Press down and hold the gap release lever. This opens the gap
between the feed and separator rollers, allowing thick documents
to pass between them. You will be able to see the gap open as the
lever is pushed down.
2. Insert the document past the rollers until it is taken into the
transport.
NOTE: If more than one thick document is to be scanned/filmed,
feed them into the transport one at a time.
Gap release lever
(hold down)
3. After the thick document(s) have been scanned/filmed, release the
gap release lever. It will return to its original position. The feed and
separator rollers will return to the previously adjusted positions.
Gap release lever
A-61096 June 1999
Advertisement
Table of Contents
