Kodak Microimager 990 User Manual page 91

Code Operator Message Displayed
E235 Turn main power OFF and ON
E236
E237 Open and close cass access door
E238 User function string invalid
E240 Enter correct level of IA — refeed
E241
E242
E243
E244
E245
E246 Conflicting input — what level?
E249 Select duo or change cassettes
E250 Use other side of upper cassette
E251 Use other side of lower cassette
E252 Check film threading - both cass
E253 Check film threading - upper cass
E254 Check film threading - lower cass
E257 AEC error — press STOP, then RUN
E258 Replace battery — upper cassette
E259 Replace battery — lower cassette
6-6
Description/Action Required
•
Turn the side panel switch off.
•
Turn the main power switch off.
•
Wait 5 to 10 seconds.
•
Turn the main power switch on.
•
Turn the side panel switch on.
If the error repeats, call service.
Open and close the cassette access door.
Press Run to continue.
The P-key, End-of-Batch, etc., definition
made during installation is invalid. Correct
the definition using Mode Setup Software.
Set or change the document image level or
use the Next key to enter a new image
address.
Press Run to continue.
Set or change the document image level to
confirm the proper document image level.
Press Run to continue.
Complete the proper setup for duo mode or
change cassette(s).
Rotate the film cassette to film on the proper
side. Reload the cassette.
Rotate the film cassette to film on the proper
side. Reload the cassette.
Check film threading in the cassettes. Press
Clear, then press Run to continue.
Check film threading in the cassette. Press
Clear, then press Run to continue.
Check film threading in the cassette. Press
Clear, then press Run to continue.
Exposure error. Press Stop, then press Run
and refeed the documents.
Replace the upper cassette battery.
Replace the lower cassette battery.
A-61096 June 1999