Table of Contents
Advertisement
Using duo mode
A-61096 June 1999
Duo mode allows you to double the number of single-sided documents
exposed on a single roll of film. This is done by rotating the cassette(s)
after the first side of the film has been fully exposed. Documents are
first exposed down one side of the film (channel A), until the end of the
roll is reached. Then, the cassette(s) are rotated and documents are
exposed down the other side of the film (channel B).
Due to the way in which documents are exposed when using duo
mode, the following recommendations are made:
•
Do not mix duo mode microfilming with simplex or duplex mode
microfilming using the same roll of film.
•
Do not unload a partially exposed roll of film created using duo
mode.
The following steps illustrate the use of duo mode:
1. Feed documents into the transport as described in the section
entitled, "Feeding documents".
2. A message appears in the status display when the first side of the
film has been fully exposed: E212 End of side 1, flip cassette .
3. Open the cassette access door.
4. Swing the drive release lever (green handle) out.
5. Remove the cassette from the upper film slot.
6. Rotate the cassette so the side two symbol (
panel (as shown). Refer to the labels inside the cassette access
door for proper orientation.
Cassette access door
Side two
symbol
Drive release
lever
7. Reinsert the cassette into the upper film slot.
8. Repeat Steps 5 through 7 for the cassette in the lower film slot.
9. Continue feeding documents. A message appears in the status
display when the second side of the film has been exposed. Refer
to the section "Unloading a fully exposed roll of film" later in this
chapter.
) faces the control
Control panel
3-7
Advertisement
Table of Contents
