Table of Contents
Advertisement
Code
Operator Message Displayed
E276
Check lens turret seating
E280
Feeder off due to host request
E281
OCR was reset — restart batch
E282
Comm buffer full — please wait
E283
Invalid configuration for OCR
E284
OCR initializing — please wait
E285
Feeder off due to OCR request
E286
Feed calibration target
E287
Feeder waiting for AEC
E288
OCR batch stopped due to error
E291
Scanner/microimager disabled
6-8
Description/Action Required
Rotate the lens turret so it is locked in place.
System is busy. The feeder will be
reactivated when the system is no longer
busy.
Wait until the message clears and continue.
Use the Next key to enter a starting image
address.
Rerun the batch.
System is busy. Wait until the message
clears, then continue.
OCR is not enabled in the mode selected.
Enable the OCR using function code F76, or
change the application mode to one in which
the OCR is enabled.
System is busy. Wait until the message
clears, then continue.
System is busy. Feeder will be reactivated
when the system is no longer busy.
Wait until the message clears, then continue.
Calibration process has started.
Press Run and feed the calibration target
into the transport.
•
Turn the side panel switch off.
•
Turn the main power switch off.
•
Wait 5 to 10 seconds.
•
Turn the main power switch on.
•
Turn the side panel switch on.
If the error repeats, call service.
Determine the cause of the error via the
OCR workstation interface.
Correct the error. Rerun the batch.
The machine has been disabled due to an
error. Determine the cause of the error via
the host system.
Enable the machine and press Run to
continue.
A-61096 June 1999
Advertisement
Table of Contents
