Kodak Microimager 990 User Manual page 94

Code Operator Message Displayed
E292 Lamp failure
E293 Host recovery required
E294 Front calibration warning
E295 Rear calibration warning
E296 Target not seen
E297 Document queue full
E298 Calibration required
E500
System error
E501
E502
E503
E512
E513
E550
E551
E552
E553
E562
E563
A-61096 June 1999
Description/Action Required
Replace the exposure lamps. Recalibrate the
scanner/microimager.
Contact your system administrator to initiate
the required action on the host system.
Perform maintenance procedures for the
Document Scanning Array, imaging guides,
etc.
Check the lamps; replace if necessary.
Recalibrate the machine.
Perform maintenance procedures for the
Document Scanning Array, imaging guides,
etc.
Check the lamps; replace if necessary.
Recalibrate the machine.
Repeat the calibration process using a blank
target. If error repeats, call service.
The feeder and transport are stopped and
the machine is disabled.
Transfer images from the image buffer to the
host system.
Re-enable the machine. Press Run to
continue.
Enter function code F37 to initiate the
calibration sequence.
Contact your system administrator.
A controlled power-down sequence is
required.
6-9