Table of Contents
Advertisement
Feeding documents
A-61096 June 1999
After the scanner/microimager has been prepared for operation, and
the desired mode and any temporary operating values have been
defined, you are ready to feed documents into the transport.
1. Verify the side panel switch is on and all proper adjustments have
been made (feeder side guides, exit hopper side guides, etc.).
2. Press Run.
3. Select a stack of documents that is no more than a ½-inch (1 cm)
thick.
4. Fan the stack of documents so the leading edge of the top
document engages the feed/separator rollers as shown:
5. Place the stack of fanned documents into the feeder so the leading
edge of the top document contacts the feed/separator rollers. The
documents are drawn into the transport, with the top document
being fed first. The documents are deposited in the exit hopper
face down, in the order in which they were fed into the transport.
6. Repeat Steps 3 through 5 until all of the application documents
have been fed into the transport.
7. Press Stop after all documents have been deposited in the exit
hopper.
NOTE: When using simplex or duplex mode, the fully or partially
exposed roll(s) of film can be unloaded when the
application is completed. When using duo mode, refer to
the section "Using duo mode" later in this chapter.
3-5
Advertisement
Table of Contents
