Table of Contents
Advertisement
Unloading film
cassette(s)
Unloading a fully
exposed roll of film
3-8
You may unload a fully or partially exposed roll of film.
Always load and unload film in subdued, indirect light
IMPORTANT:
to help prevent "fogging. "
Use the following steps to unload a fully exposed roll of film (simplex,
duplex, or duo format).
It is assumed that all documents have been deposited in the exit
hopper and Stop has been pressed.
1. Perform function code F29 (Advance Film to End of Roll).
2. Open the cassette access door.
3. Swing the drive release lever (green handle) out.
4. Remove the film cassette(s).
5. Place the cassette on a flat surface, with the top cover side up.
6. Press down on the cover latch and turn it counterclockwise to
unlock the cover.
7. Remove the top cover and set it aside.
8. Place a finger over the take-up spool flange to prevent the film
from unwinding and lift up to remove the spool of film.
9. Place the spool into the film box. Allow approximately 2 to 3 in.
(5 to 8 cm) of the film to protrude from under the lid of the box (as
shown). Close the top of the box securely.
2 to 3 inches
(5 to 8 cm)
10. Write identification data (i.e., subject, title, date, job number, etc.)
on the film box label. The film is now ready for processing.
NOTE: Replace the top cover back on the cassette(s), regardless
of whether or not you immediately reload the cassette.
This helps to extend battery life.
A-61096 June 1999
Advertisement
Table of Contents
