Table of Contents
Advertisement
If the documents are larger than the area shown on the feed shelf
label, and do not fit between the side guides, rotate and reposition the
documents within the side guides. If the documents still do not fit within
the label boundaries and extend past the side guides, you may have
selected an incorrect lens reduction and/or film mode for the size of
your documents. Refer to the section entitled, "Selecting a lens
reduction" earlier in this chapter. This section lists the maximum
document size allowed by each lens reduction and microfilming mode.
The following examples show the correct placement of the feed shelf
side guides for each possible combination of lens reduction and film
mode:
24X reduction ratio; simplex film mode
50X reduction ratio; simplex film mode
Center Line
Center the documents, allowing approximately 1/16 in. (2 mm)
clearance on each side of the documents so they feed properly.
40X reduction ratio; simplex film mode
Center Line
Left feeder side guide should be aligned here
Set the left feed shelf guide side shelf where indicated.
Set the right feed shelf side guide dependent upon the width of the
document, allowing approximately 1/16 in. (2 mm) clearance on each
side of the documents so they feed properly.
A-61096 June 1999
2-17
Advertisement
Table of Contents
