Chapter 3 Installation And Getting Started; Setup Overview; Power Saver Mode And Activating The Scan Station - Kodak Scan Station 700 Administrator's Manual

Chapter 3 Installation and Getting Started

Setup overview

Power saver mode
and activating the
Scan Station
A-61796 January 2017
Following is a list of things you need to do to prepare for configuring
your Scan Station 710/730EX.
• Unpack your Scan Station(s) according to the unpacking instructions
in the box that your Scan Station was packaged in.
• Setup the Scan Station and make the necessary connections. See
the Installation Guide or "Setting up the Scan Station" on page 2.
• Review the pre-installation checklist in Chapter 2 and gather all of the
information required to configure the Scan Station. Having this
information available in advance will help ensure an easy Scan
Station configuration.
• When the Scan Station is properly connected, press the power button
and wait a few moments for the Scan Station to start up and display
the application.
• Install the Kodak Scan Station 700 Series - Scanner Administration
application on a separate PC. See "Installing the Kodak Scan Station
700 Series - Scanner Administration application" on page 16 for
procedures.
By default, after 15 minutes of inactivity, the Scan Station will
automatically enter into power saver mode.
To activate the Scan Station from power saver mode press the power
button.
15