Kodak Microimager 990 User Manual page 92

Code Operator Message Displayed
E260 Check cassette insertion
E261 Check upper exposure lamps
E262 Check lower exposure lamps
E263 Check film threading — upper cass
E264 Check film threading — lower cass
E265 Clear error, re-enter lead code
E266 Clear error, re-enter trail code
E267 Clear error, re-enter IA
E268 Clear error, advance film
E269 Use cassette side 1
E270 Use cassette side 2
E271 Wrong lens for film mode
E272 Select proper mask for film mode
E275 Select proper lens for this mode
A-61096 June 1999
Description/Action Required
Verify the cassette(s) are in the proper
position and are properly inserted. Press
Run to continue.
Replace the upper exposure lamps.
Replace the lower exposure lamps.
Verify that the film is threaded properly in the
upper cassette. If it is not threaded properly,
rethread the film. Press Clear, then press
Run to continue.
Verify that the film is threaded properly in the
lower cassette. If it is not threaded properly,
rethread the film. Press Clear, then press
Run to continue.
Press Clear and enter function code F31 to
generate the lead end code.
Press Clear and enter function code F32 to
generate the trail end code.
Press Clear, use the Next key to enter an
image address and press Run to continue.
Press Clear, enter function code F27 to
advance film and press Run to continue.
Insert the film cassette so side 1 will be
exposed.
Insert the film cassette so side 2 will be
exposed.
Change the lens reduction to match the film
mode selected, or change the application
mode to one where the specified film mode
and lens reduction are compatible.
Select the proper mask to match the film
mode selected, or change the application
mode to one where the specified film mode
and mask are compatible.
Select the proper lens reduction to match the
film mode selected, or change the
application mode to one where the specified
film mode and lens reduction are compatible.
6-7