Table of Contents
Advertisement
3
GETTING STARTED
Turning on the Scanner
Selecting the language
display
A-41069
January 1993
The following steps are necessary to prepare the Scanner for operation:
• Turn on the Main Power Switch (located at the rear of the machine).
• Turn on the Side Panel Switch.
• Select the language display.
• Calibrate the Scanner.
• Adjust the Feed and Separator Roller gap.
• Adjust the Feed Shelf position.
• Adjust the Feed Shelf Side Guides.
• Adjust the Exit Hopper Side Guides and End Stop.
• Change the Deflector (if required).
• Prepare documents for scanning.
The following steps are required to power on the Scanner:
1. Turn on the Main Power Switch (located at the rear of the
machine).
NOTE: It is not necessary to turn off the Main Power Switch during
normal daily operation.
2. Turn on the Side Panel Switch.
Wait until the Status Display indicators are lit and an operating
display appears before you continue.
0030.05.100.001
The Scanner may have been configured at installation to allow use of a
second language in the status display. The language used (French,
German, Italian, Spanish, or other) is defined during installation. If
available, the alternate language display may be accessed using Function
Code F19.
MODE 1
3 - 1
Advertisement
Table of Contents
