Parameter Warning Codes - Omron 3G3MX2 User Manual

Monitoring Trip Events, History, & Conditions
6-2-3

Parameter Warning Codes

276
Error Code
Rotat-
ing
Blinking Communication
Note Reset is not allowed in 10 second after trip.
Note When error E08, E14 and E30 occur, reset operation by RS terminal or STOP/
RESET key is not accepted. In this case, reset by cycling power. If still same
error occurs, perform initialization.
If set parameter is conflicted to other parameters, warning code is displayed
as follows.
Warning
code

Frequency upper limit ()

Frequency lower limit ()

Output frequency setting/
monitor () Multi-step speed
reference 0 ()

Output frequency setting ()
Multi-step speed reference 0
()

Frequency lower limit ()

Starting frequency ()

Starting frequency ()

Starting frequency ()

Starting frequency ()

Starting frequency ()
Name
Reset RS input is ON or STOP/RESET key is
pressed.
Undervoltage If input voltage is under the allowed level,
inverter shuts off output and wait with this indi-
cation.
Waiting to restart This indication is displayed after tripping before
restarting.
Restricted oper- Commanded Rotation direction limit selection is
restricted in .
ation command
Trip history Trip history is being initialized.
initializing
No data No trip/waning data exists.
(Trip monitor)
Communication between inverter and digital
error operator fails.
Auto-tuning Auto-tuning is completed properly.
completed
Auto-tuning error Auto-tuning fails.
Warning conditions
Section 6-2
Descriptions
> Maximum Frequency ()
> Maximum Frequency ()
> Maximum Frequency ()
> Frequency upper limit ()
> Output frequency setting ()
Multi-step speed reference 0
()
> Frequency upper limit ()
> Frequency lower limit ()
> Output frequency setting ()
Multi-step speed reference 0
()
> Multi-step speed reference 1 to
15 (-)
> Jogging frequency ()